Products Catalog

Specification

Fits Some Post-1995 Multi-Pumps w/ Cartridge Valve

Repair kit fits these multi-pump guns made after 1995 & they have a compression tube that slides out of the assembly & does not need a special tool ( has a cartridge valve & the valve is NOT soldered) . It may be necessary to push out the assembly from the front of the tube: Benjamin 397 & 392 guns as well as Sheridan C9 ( Silver Streak) & CB9 ( Blue Streak) . To determine if this kit is for you:

* Remove the screw in front of triggerguard to remove rear part of the stock
* Remove the pins or screws that hold the retention cap at the rear of the receiver
* Remove the guide pin, spring & hammer to reveal the compression tube
* If the brass compression tube comes out in one piece, then this is the kit you need
* If your gun has a rounded square hole with a valve stem sticking up through it, then you need the other repair kit ( CR/ Repairkit)

Consist of ;
1 pc SHERIDAN_Chamber O-ring, Front ( # P906/ JTX-090)
1 pc SHERIDAN_Chamber O-ring, Inner ( # 397-037)
1 pc SHERIDAN_Chamber O-ring, Rear ( # 397-036)
1 pc SHERIDAN_Teflon Inlet Valve ( # 1322-056)
1 pc BENJAMIN/ SHERIDAN_Outlet Valve ( # 397-038)
1 pc BENJAMIN/ SHERIDAN_Hycar Pump Washer ( # C-218)