Specification :

Introduction:
GWT10100E-DIP media converter is 10Mbps Ethernet and 100M fast Ethernet converter. The converter mediates between a 10baseT/ 100Base-Tx segment and a 100Base-FX segment. It is primarily designed for large, higher speed/ bandwidth demanding workgroups that require expansion of the Ethernet network. It can extend the conventional 10M Ethernet or 100M Fast Ethernet to 120Km max. via fiber-optic cable. It is high-performance, cost effective and flexible solution for a wide range of applications in the field of LAN campus network.

Definition of DIP switch
1--AUTO TEST Auto loop back test
1( on) : enable
When IP113A detects a low-to-high transition on this pin, it will perform loop back test for once.
0( off) : disable ( default)

2--LFP Link fault pass through ( LFP)
1( on) : enable
Link status of one port is forwarded to the other port.
0( off) : disable ( default)

3--AUTO SEND
Auto send the status to the remote IP113A
1( on) : enable
0( off) : disable ( default)

4--TP FORCE
Local TP port auto negotiation enable
1( on) : TP port supports auto-negotiation with limited capability defined in SPEED_MODE and DUPLEX_MODE.
0 ( off) : TP port supports auto-negotiation with 10M/ 100M, full/ half
capability ( default)

5--DUP
Local TP port duplex
1( on) : TP port has the Full duplex ability
0( off) : TP port has the Half duplex ability only

6--SPD Local TP port speed
1( on) : TP port has the 100Mb speed ability
0( off) : TP port has the 10Mb speed ability only