Specification :

ABA 7/ 35 ASPHALT BINDER ANALYSER
Specification :
Maximum operating temperature 750
Internal chamber dimension
Height ( mm) 220
Width ( mm) 350
Depth ( mm) 450
TC Type K
Maximum power ( KW) 8, 0
External dimension :
Height ( mm) 980
Width ( mm) 600
Depth ( mm) 750
Weight ( kg) 120
The furnace is rated at 8 KW for operation on 208/ 240 volts, 50/ 60 Hz, three or single phase. The furnace holding power is approximately 3 KW.
Benefits
- The ability automatically calculated and use calibration factors bassed on both asphalt mixes and dry aggregates.
- Unique automatic input of sample start weight via an optional second external orhaus balance, which eliminates operator error.
- Rapid heat up rates permit the unit to be switched off between tests. Resulting in reduced power consumption and eliminating the need for a to 24-hour time.
- Customisation of test parameters and ability to save named test set up in a library.
- Choice of print format: either continuously throughout the test showing the result as minute intervals of a final end of test analysis.
- Permits large sample size ( up to 4, 5 kg ) to be tested.
- Precise measurement-weight measured to 0, 1 g.
- Uses Friendly design.
- Cost saving due to reduction in testing time and elimination of costly chemicals.
Safety Features
- Automatic door locking during testing which cannot be disabled by interruption of the power supply once the test has commenced.
- Door safety switch isolates-power to the element when the door is opened.
- Independently controlled after burner significantly reduces furnace emissions, as specified by the test standards.
- Eliminates health and environmental concern realated to the use of chlorinated solvents.