PIC18F2525-I/ P Microchip MCU ( Rp. 200.000, -)

Quantity Order:

Origin:

Indonesia

Payment Method:

Telegraphic Transfer (T/T)

40-Pin Enhanced Flash Microcontrollers
with 10-Bit A/ D and nanoWatt Technology.
----------------

Power Managed Modes:
• Run: CPU on, peripherals on
• Idle: CPU off, peripherals on
• Sleep: CPU off, peripherals off
• Idle mode currents down to 2.5 ¼ A typical
• Sleep mode current down to 100 nA typical
• Timer1 Oscillator: 1.8 ¼ A, 32 kHz, 2V
• Watchdog Timer: 1.4 ¼ A, 2V typical
• Two-Speed Oscillator Start-up

Flexible Oscillator Structure:
• Four Crystal modes, up to 40 MHz
• 4x Phase Lock Loop ( PLL) – available for crystal
and internal oscillators)
• Two External RC modes, up to 4 MHz
• Two External Clock modes, up to 40 MHz
• Internal oscillator block:
- 8 user selectable frequencies, from 31 kHz to
8 MHz
- Provides a complete range of clock speeds
from 31 kHz to 32 MHz when used with PLL
- User tunable to compensate for frequency drift
• Secondary oscillator using Timer1 @ 32 kHz
• Fail-Safe Clock Monitor
- Allows for safe shutdown if peripheral clock stops

Peripheral Highlights:
• High-current sink/ source 25 mA/ 25 mA
• Three programmable external interrupts
• Four input change interrupts
• Up to 2 Capture/ Compare/ PWM ( CCP) modules,
one with Auto-Shutdown ( 28-pin devices)
• Enhanced Capture/ Compare/ PWM ( ECCP)
module ( 40/ 44-pin devices only) :
- One, two or four PWM outputs
- Selectable polarity
- Programmable dead time
- Auto-Shutdown and Auto-Restart

Peripheral Highlights ( Continued) :
• Master Synchronous Serial Port ( MSSP) module
supporting 3-wire SPIâ„¢ ( all 4 modes) and I2Câ„¢
Master and Slave modes
• Enhanced Addressable USART module:
- Supports RS-485, RS-232 and LIN 1.2
- RS-232 operation using internal oscillator
block ( no external crystal required)
- Auto-Wake-up on Start bit
- Auto-Baud Detect
• 10-bit, up to 13-channel Analog-to-Digital
Converter module ( A/ D) :
- Auto-acquisition capability
- Conversion available during Sleep
• Dual analog comparators with input multiplexing
• Programmable 16-level High/ Low-Voltage
Detection ( HLVD) module:
- Supports interrupt on High/ Low-Voltage Detection

Special Microcontroller Features:
• C compiler optimized architecture:
- Optional extended instruction set designed to
optimize re-entrant code
• 100, 000 erase/ write cycle Enhanced Flash
program memory typical
• 1, 000, 000 erase/ write cycle Data EEPROM
memory typical
• Flash/ Data EEPROM Retention: 100 years typical
• Self-programmable under software control
• Priority levels for interrupts
• 8 x 8 Single Cycle Hardware Multiplier
• Extended Watchdog Timer ( WDT) :
- Programmable period from 4 ms to 131s
• Single-supply 5V In-Circuit Serial
Programmingâ„¢ ( ICSPâ„¢ ) via two pins
• In-Circuit Debug ( ICD) via two pins
• Wide operating voltage range: 2.0V to 5.5V
• Programmable Brown-out Reset ( BOR) with
software enable option

Recommend to your friends