Products Catalog

Specification

1 EEST. Unit:
Anodized aluminium structure. Panels and main metallic elements in stainless steel.
Diagram in the front panel with similar distribution that the elements in the real unit.
Solar panel (Thermal solar collector):
Steel structure.
Piped (already prepared) to connect the panel and the accumulator.
Closed expansion vessel.
Over pressure security valve.
Two manometers.
Temperature sensors.
Thermal accumulator tank:
Vacuum vitrified heater, high efficiency heating and anticorrosion protections.
It has a supporting heating group, with a regulation electric resistor.
Contact thermostat to control temperature.
Solar simulator:
Aluminium structure regulated in height.
Sixteen ultraviolet lamps of 300 W each one.
Electricity security group, made up by 3 magnetothermic.
Feed wire.
Pumping equipment:
Impulse pump.
3 Flowmeters.
Temperature sensors.

2 Electronic Console:
Metallic box.
Sensor digital display for temperature sensors. Sensor selector for temperature sensors.
Pump switch.
Heater resistance switch.
Switches for lamps.

3 Cables and Accessories.

4 Manuals:
This unit is supplied with 8 manuals: Required Services, Assembly and Installation, Interface and Control Software (for computer controlled units), Starting-up, Safety, Maintenance, Calibration (for computer controlled units) & Practices Manuals.

Q Under EEST we always supply all the elements for immediate running as 1, 2, 3 and 4.

EXERCISES AND PRACTICAL POSSIBILITIES
Practical Possibilities of the Unit:
1.- Study of how the thermosiphon works.
2.- Study of the lamp illumination profile.
3.- Study of the solar collector efficiency.
4.- Free circulation: Inclination angle influence on the equipment efficiency.
5.- Relationship between the flow and the temperature.
6.- Energy balance of the solar collector.
7.- Energy balance in the accumulator tank.
8.- Experimental efficiency determination.
9.- Influence of the incidence angle over the temperature. Put on Product PartnerRecommend to your friends