The DSE7510 is an Automatic
Engine ControlModule, designed
to provide advanced load share
functionality for diesel and gas
generating sets that include nonelectronic
and electronic engines.
The module also provides
excellent engine monitoring and
protection features.
The module’ s load share functions
include automatic synchronising
with built in synchroscope and
closing onto dead bus. Direct and
flexible outputs from the module
are provided to allow connection
to the most commonly used speed
governors and automatic voltage
regulators ( AVRs) .
The module has been designed to
combine a maximum of 16
generators and 16 mains ( utility)
supplies up to a maximum of 20 in
one system, e.g. 16 generators
and 4 mains ( utility) supplies –
DSE7560 required to synchronise
with the mains ( utility) .
Themodule has the ability to
monitor generator under/ over volts,
over current, generator under/ over
frequency, under speed, over speed,
charge fail, emergency stop, lowoil
pressure, high engine temperature,
fail to start, low/ highDCbattery
volts, fail to stop, generator short
circuit protection, reverse power,
generator phase rotation error, earth
fault protection, loss of speed signal,
fail to open, fail to close, out of sync,
open circuit failure, negative phase
sequence and loss of excitation.
FEATURES
• Electronic engine capability
• RS232 or RS485 remote
communications
• Modbus RTU
• Pin number protected front panel
programming
• Exercise timer
• Back-lit LCD 4-line text display
• Multiple display languages
• Voltage measurement
• Configurable inputs ( 9)
• Configurable outputs ( 5)
• Automatic start
• Manual start
• Audible alarm
• LED indicators
• Built-in governor and AVR control
• Engine history event log
• Engine protection
• Fault condition notification to a
designated PC
• Front panel mounting
• PC configuration
• Bus failure detection
• Configurable alarm timers
• Configurable start & stop timers
• Automatic load transfer
• SMS alert messaging
• Remote monitoring
• Magnetic pick-up
• kW overload alarms
• Engine temperature alarms
LOAD SHARE FEATURES
• No-break transfer
• Peak shaving/ peak lopping
• Sequential set start
• kW on mains ( utility) level
• Mains ( utility) decoupling test mode
• Manual speed/ frequency adjust
• ROCOF & vector shift
• Generator load demand
• Automatic hours run balancing
• Dead bus sensing
• Existing load share line interfacing
( P123 required)
• Direct governor & AVR
communication
• Volts & frequency matching
• kW and kVAr load sharing
• Manual voltage adjust
• Auto ID negotiation
BENEFITS
• Sends SMS messages to
engineers to notify specific
engine problems ( GSM Modem
and SIM card required)
• On-site and remote ( modem
required) module configuration
• In-built engine diagnostics
removes the requirement for
service equipment
• Full engine protection &
instrumentation without the need
for additional senders ( Electronic
engines only)
• Remote monitoring of the module
using comprehensive DSE PC
software
• License free PC software