Specification :

ÃŽ Applications:
Long distance telephone, CATV, Data communications.
ÃŽ Installations:
Installed in duct, self supporting (Figure 8 self supporting or ADSS All dielectric self supporting) and direct
burial (with armouring).
ÃŽ Construction:
The cable consists of a single tube containing 2 up to 24 fibers, which is filled with water-blocking gel. When the
cable contains more than 12 fibers, they are divided in two groups. A colored thread identifies each group. Physical
protection and tensile strength are provided by aramid yarn or fiberglass wound around the tube. Either PE or LSZH
jacket can be used. A ripcord is located under the jacket to facilitate jacket removal.
ÃŽ Technical Parameters:
 Maximum Transmission Distance: 6km (Single Mode); 0.3km (Multimode)
 Maximum Pulling Load: 1500N (Short Term Installation); 900N (Long Term Installation)
 Maximum Compressive load: 3000N (3.3mm loose tube diameter); 5000N (4.5mm loose tube diameter)
 Twist (Torsion Length): 125 x Overall Diameter
 Working Temperature: -20 ~ +70 (PE sheath)
 Storage Temperature: -40 ~ +70 (PE sheath)
ÃŽ Product Highlights:
 Small diameter and light weight.
 Through the control of the fiber exceed length which is the key technology in optical fiber manufacture, the fiber
cable can achieve better pulling load and operating temperature.
 Tube Materials are water resistant and can sustain high tension. Being filled with special water-blocking gel, the
tube can provide water protection for the fibers inside the tube.
 Compact construction of the fiber cores can prevent the fiber to shrink back. This can sustain higher tensile stress
and achieve better flexibility.
 Wide operating temperature range.