Specification :
Detail: Technical specification
SPECIFICATION ( valid for each programming module)
HARDWARE
Base unit, DACs
USB 2.0 port
on-board intelligence: powerful microprocessor and FPGA based state machine
three D/ A converters for VCCP, VPP1, and VPP2, controllable rise and fall time
VCCP range 0..8V/ 1A
VPP1, VPP2 range 0..26V/ 1A
autocalibration
selftest capability
protection against surge and ESD on power supply input, parallel port connection
Socket, pindriver
48-pin DIL ZIF ( Zero Insertion Force) socket accepts both 300/ 600 mil devices up to 48-pin
pindrivers: 48 universal
VCCP / VPP1 / VPP2 can be connected to each pin
perfect ground for each pin
FPGA based TTL driver provides H, L, CLK, pull-up, pull-down on all pindriver pins
analog pindriver output level selectable from 1.8 V up to 26V
current limitation, overcurrent shutdown, power failure shutdown
ESD protection on each pin of socket ( IEC1000-4-2: 15kV air, 8kV contact)
continuity test: each pin is tested before every programming operation
DEVICE SUPPORT ( valid for each programming module)
Programmer
EPROM: NMOS/ CMOS, 2708, 27xxx and 27Cxxx series, with 8/ 16 bit data width, full support for LV series
EEPROM: NMOS/ CMOS, 28xxx, 28Cxxx, 27EExxx series, with 8/ 16 bit data width
Flash EPROM: 28Fxxx, 29Cxxx, 29Fxxx, 29BVxxx, 29LVxxx, 29Wxxx, 49Fxxx series, from 256Kbit to 32Mbit, with 8/ 16 bit data width, full support for LV series
Serial E( E) PROM: 24Cxxx, 24Fxxx, 25Cxxx, 45Dxxx, 59Cxxx, 25Fxxx, 25Pxxx, 85xxx, 93Cxxx, NVM3060, MDAxxx series, full support for LV series
Configuration ( EE) PROM: XCFxxx, XC17xxxx, XC18Vxxx, EPCxxx, AT17xxx, 37LVxx
1-Wire E( E) PROM: DS1xxx, DS2xxx
PROM: AMD, Harris, National, Philips/ Signetics, Tesla, TI
NV RAM: Dallas DSxxx, SGS/ Inmos MKxxx, SIMTEK STKxxx, XICOR 2xxx, ZMD U63x series
PLD: Altera: MAX 3000A, MAX 7000A, MAX 7000B, MAX 7000S, MAX7000AE
PLD: Lattice: ispGAL22V10x, ispLSI1xxx, ispLSI1xxxEA, ispLSI2xxx, ispLSI2xxxA, ispLSI2xxxE, ispLSI2xxxV, ispLSI2xxxVE, ispLSI2xxxVL, LC4xxxB/ C/ V/ ZC, M4-xx/ xx, M4A3-xx/ xx, M4A5-xx/ xx, M4LV-xx/ xx
PLD: Xilinx: XC9500, XC9500XL, XC9500XV, CoolRunner XPLA3, CoolRunner-II
other PLD: SPLD/ CPLD series: AMI, Atmel, AMD-Vantis, Gould, Cypress, ICT, Lattice, NS, Philips, STM, VLSI, TI
Microcontrollers 48 series: 87x41, 87x42, 87x48, 87x49, 87x50 series
Microcontrollers 51 series: 87xx, 87Cxxx, 87LVxx, 89Cxxx, 89Sxxx, 89LVxxx, all manufacturers, Philips LPC series
Microcontrollers Intel 196 series: 87C196 KB/ KC/ KD/ KT/ KR/ ...
Microcontrollers Atmel AVR: AT90Sxxxx, ATtiny, ATmega series
Microcontrollers Cypress: CY8Cxxxxx
Microcontrollers ELAN: EM78Pxxx
Microcontrollers MDT 1xxx and 2xxx series
Microcontrollers Microchip PICmicro: PIC10xxx, PIC12xxx, PIC16xxx, PIC17Cxxx, PIC18xxx, dsPIC series
Microcontrollers Motorola ( Freescale) : 68HC05, 68HC08, 68HC11 series
Microcontrollers Myson MTV2xx, 3xx, 4xx and 5xx series
Microcontrollers National: COP8xxx series
Microcontrollers NEC: uPD78xxx series
Microcontrollers Scenix ( Ubicom) : SXxxx series
Microcontrollers SGS-Thomson: ST6xx, ST7xx, ST10xx series
Microcontrollers TI: MSP430 and MSC121x series
Microcontrollers ZILOG: Z86/ Z89xxx and Z8xxx series
Microcontrollers other: EM Microelectronic, Fujitsu, Goal Semiconductor, Hitachi, Holtek, Princeton, Macronix, Winbond, Infineon( Siemens) , NEC, Samsung, Toshiba, ...
Package support
support all devices in DIP with default socket
package support includes DIP, SDIP, PLCC, JLCC, SOIC, SOP, PSOP, SSOP, TSOP, TSOPII, TSSOP, QFP, PQFP, TQFP, VQFP, QFN ( MLF) , SON, BGA, EBGA, FBGA, VFBGA, UBGA, CSP, SCSP etc.
support devices in non-DIP packages up to 48 pins with universal adapters
programmer is compatible with third-party adapters for non-DIP support
Programming speed
Notes:
It is important to know, we always use random numbers pattern for programming speed testing. Some our competitors use " sparse" pattern, where only few non-Blank data are programmed or are there are used data with only few 0 bits ( FE, EF, etc.) . This cheating approach can " decrease" programming time considerable. If you plan to compare, ask always which pattern they use.
The programming speed depends on PC speed only slightly.
SOFTWARE
Algorithms: only manufacturer approved or certified algorithms are used. Custom algorithms are available at additional cost.
Algorithm updates: software updates are available approx. every 2 weeks, free of charge.
Main features: revision history, session logging, on-line help, device and algorithm information
Device operations
engineering mode
standard:
intelligent device selection by device type, manufacturer or typed fragment of part name
automatic ID-based selection of EPROM/ Flash EPROM
blank check, read, verify
program
erase
configuration and security bit program
illegal bit test
checksum
security
insertion test, reverse insertion check
contact check
ID byte check
special
production mode ( automatic start immediately after device insertion)
auto device serial number increment
statistic
count-down mode
production mode
All operations are controlled by project file.
standard:
blank check, read, verify
program
erase
configuration and security bit program
illegal bit test
checksum
security
insertion test, reverse insertion check
contact check
ID byte check
special
production mode ( automatic start immediately after device insertion)
auto device serial number increment
statistic
count-down mode
Buffer operations
Only for engineering mode.
view/ edit, find/ replace
fill/ copy, move, byte swap, word/ dword split
checksum ( byte, word)
print
Supported file formats
unformatted ( raw) binary
HEX: Intel, Intel EXT, Motorola S-record, MOS, Exormax, Tektronix, ASCII-space-HEX
Altera POF, JEDEC ( ver. 3.0.A) , e.g. from ABEL, CUPL, PALASM, TANGO PLD, OrCAD PLD, PLD Designer ISDATA, etc.
SPECIFICATION ( BeeHive4 multiprogramming system)
4x universal programming module ( 4x 48-pin DIL ZIF sockets)
operation result LEDs, LED power
USB 2.0 port
Line power input 100-240VAC/ 60W max.
banana jack for ESD wrist straps connection
PC system requirements
Microsoft Windows 2000/ XP/ 2003/ XP64 ( XP and above recommended)
PC Pentium 4; 1.3 GHz ( 2GHz and above recommended)
256 MB of RAM ( 512MB and above recommended)
50 MB of free disk space ( * 1)
USB port 2.0 ( 2.0 high-speed recommended)
Note ( * 1) : Free disk space requirement depends also on used IC device size. For large devices the required free space on disk will be approximately 60MB + Device size
GENERAL
operating voltage AC 100-240V, max.1.2A, 50-60Hz
power consumption max. 60W active
dimensions 506x213x86 mm ( 19.9x8.4x3.4 inch)
weight ( programmer) 4.8kg ( 10.58 lbs)
temperature 5C 40C ( 41F 104F)
humidity 20% ..80% , non condensing
Package included
Standard accessories
BeeHive4 programmer
USB connection cable PC-programmer
diagnostic POD for selftest of the programmer ( 1x)
anti-dust cover for ZIF socket ( 4x)
user manual
software CD
registration card
calibration test report
transport case
Bonus pack:
ESD wrist strap with cord and banana plug
Vacuum pen
Gift ( surprise)
Additional services
Keep Current.
AlgOR
free technical support ( phone/ fax/ e-mail) .
free lifetime software update via Web site.
Model Number: HSE026
Brand Name: ELM32 VAG
Payment Terms: paypal/ TT/ w
Minimum:
Certification:
Delivery Time: 3-5days
Supply Ablity: