Specification :

Characteristics

1. Selective bed width:
S series: 300mm
M series: 350mm
L series: 400mm
2. Varied spindle bore diameters:
S series: Ø 58mm / Ø 78mm( Optional)
M series: Ø 85mm
L series: Ø 85mm / Ø 115mm( Optional)
3. With imported bearings installed on spindle, maximum cutting depth can be 8mm and roundness reaching 0.003mm ( 200mm long) .
4. Equipped with plastic rear gears, shafts and gears inside headstock are well protected if crash should occur. ( S series)
5. Thermal treated and precision ground alloy gears.
6. Universal gearbox for both imperial and metric threading – converting table also attached.
7. Tracks of cross slide and bed are well lubricated with lubrication pump ( manual) .
8. Overload device to ensure safely when operating.
9. Wear-resistant phosphor bronze lead screw nuts.
10. Double reservoir oil bath type cross slide. ( for S series)
11. Thermal treated Meehanite cast bed, hardness of bed reaching HS70.
12. One-piece base with high rigidity and low vibration.
13. High-capacity coolant tank offers sufficient coolant output.

Bearings on the spindle are imported from Germany.
Varied spindle bore diameters:
Plastic gear on the rear side of headstock. ( Opt.)
S series: Ø 58mm & Ø 78mm( Opt.)
M series: Ø 85mm
L series: Ø 85mm & Ø 115mm( Opt.)