Specification :

Cable Tray Roll Forming Machine GWC 600
Equipment capabilities:
This combination cable tray roll forming machine can produce many kinds of specification electric cable bridges and other structure product.
Product speed by punching: 2.5^ 5m/ min
Continuous rollforming speed: 5^ 12m/ min
Material thickness: 1~ 2.5mm
Material require: Q235 cold roll steel
Production line has two operating mode: automatic and manual , may realize the linkage and the partition revolution work.
Main composition of machine:
This combination cable tray roll forming machine consists of the decoiler, flatting, punch die, servo feeding, guider, main roll forming machine, following cutting, encoder, electrical control cabinet; etc.

Each part major technical parameters
1) Drive decoiler
Material width d850mm
Material weight 6000kg
Material inner diameter 460^ 510mm
Material outer diameter 1200mm
Drive power: no power, manual, passive decoiler
2) Flatting
Working rolls: 11 rolls, up 4/ down 5, the residual 2 rolls is clamp deliver rolls.
Flatting bound: material thickness 1^ 2.5mm, material width 100^ 850mm
flatting speed: 3^ 10 m/ min
3) Continual punching mould
Amount: Each kind of width specification 1 set dies, total 6 sets
Die require: Cr12 quench
4) Servo feeding set
Multistage type feeding, memory ten group of memory functions
Man-machine contact surface numerical control system
5) Holds material ( use in cushion section)
The roller type, the both sides have the bearing support, 3 sets, use in holding the material and under the deposited material spacing.
6) Guider
A pair of horizontal roller and two pairs of vertical guide rolls, total 1 sets.
7) Main roll forming machine
Rack structure: Dragon Gate type memorial arch frame
rolling steps: 16 steps
Forming variety: bridge frame
material max width: 850mm
material max thickness: d2.5mm
forming width: 100^ 600mm
forming height: 50^ 150mm
The diameter of the roller axis: à 85mm
Roll mould material: Gcr15, quenching treatment: HRC58-62°
Drive type: 15kw frequency conversion electromotor
Autocephaly distribute gear case
8) Hydraulic cutting
Hydraulic pumping station: 11kw
blade cuttimg, blade material Cr12, quench treatment
9) Electrical control

operation control cubicle
Amount: 1 set
Frequency conversion: 3sets( in main control cubicle, control decoiler, flatting and roll forming machine)
PLC control: 1 set
touchscreens
All electrical element is the Mitsubishi original installation brand