Jual pH pulse output controller, Hub. Bp. Sinaga, Hp. 0815 1311 6206, tlpn/ fax: 021 470 4719, email: pro.teknik@ yahoo.co.id[Nov. 30, 2010 20:48:53]
Specification
LMI Controllers
pH pulse output controller
Use with flow and level switches to stop pump in case of blockage or chemical exhaustion
Pulse output models feature three point proportional control for precise measurements
These wall-mount controllers feature either on/ off or pulse output with optional isolated 4 to 20 mA output. Compatible electronic diaphragm pumps are listed below to simplify for system' s component selection.
All controllers accept pH probes with 1 k© Pt RTD ATC — order from pages 662-669. Controller also accepts contact closures from flow and level switches to stop pump operation in the event of blockage or chemical exhaustion. Remote on/ off enables use with another control system.
Use the three-point proportional control capability found with pulse output controllers ( 57300-20, -30) to define two slopes of flow rate vs. pH. This feature is ideal for either fine-tuning the pump output when conditions require rapid chemical addition.
Backlit L
Controllers with pulse output are compatible with 74501-, 07100-, and 74500-series pumps--no need for a separate timer to " translate" pulse signal.
Specifications
Control type proportional
No. of inputs one
No. of inputs numeric 1
No. of setpoints two
pH accuracy 0.02
Washdown/ Nema 4 ratings No
mV display/ ORP capable No
pH range Max 14
pH range 0 to 14
min 0
RS-232 interface No
Fluid temperature Max 212
min 32
Password protection Yes
Power requirements 115 VAC, 230 VAC
Power requirements min 115
Mounting type wall-mount
Agency approvals None
Buffer recognition No
Adjustable deadband/ hysteresis Yes
Built-in/ Integral Pump No
Built-in Recorder No
Temp compensation Automatic-1000 Ohm
Relay output 3
Brand LMI
Manufacturer number DP5000-1B-0
Model DP5000-1B-0
Put on Product PartnerRecommend to your friends