Specification :

Introduction
The Re-usable Syringe Filter holders are unaffected by chemicals and contains no trace elements which could be released into the liquid being filtered. It is therefore extremely well suited for particle removal for sample preparation.

Feature
Compatibility Chemical resistance as for polycarbonate and silicone
Dead volume Less than 0.3 ml after bubble point
Filter Requires 13, 25, 50 mm diameter membrane filter
25 mm diameter Filtration area 3 cm2
Flow rates Typical values for water at 1 bar (100 kPa), 70 ml/min with 0.2¼m, 110 ml/min with 0.45 ¼m pore size filters
Materials polypropylene top and bottom part. Silicone gasket (20.5 x 26.5mm, replacement for a pack of 10)
Pressure limit Max. operating pressure, 7 bar (700 kPa)
Sterilisation By autoclaving (121°C)
Application
Gas particulate and bacteria filtration and then inspect them
Oil particulate and bacteria filtration and then inspect them
Alcohol particulate and bacteria filtration and then inspect them
Other solvent particulate and bacteria filtration and then inspect them