Three-rings and Medium-speed Micropowder Grinder

Quantity Order:

Origin:

China

Payment Method:

Telegraphic Transfer (T/T), Cashier Order, Bank Cheque, L/C

Quantity:

1 set

Three-rings and Medium-speed Micropowder Grinder:
HGM series of Three-Ring & Medium-Speed MicroPowder Grinder is a new kind of micro-powder processing equipment, which is invented through more than twenty times experiments and improvements, and based on twenty years of mill manufacture experience while absorbing advanced international machine manufacture techniques. HGM series of Three-Ring & Medium-Speed MicroPowder Grinder is mainly used in processing non-inflammable, non-explosive, brittle material with hardness below six mohs, such as calcite, chalk, limestone, dolomite, kaolin, bentonite, talc, mica, magnesite, pyrophillite, ceyssatite, barite, gypsum, alunite, granite, fluorite, phosphate rock, kalium ore, float stone, more than 200 kinds of materials.

Working principle:
The motor drives the main shaft and every turnplate through the reducer. The reducer drives dozens of rollers to rotate against race way of ring through pin. Small materials crushed by hammer crusher is transported into hopper by elevator, and then vibrating feeder shall feed material to the central part of upper turnplate evenly. The material falls to circle under the centrifugal force and comes down to raceway of ring to be crushed into powder. After grinded in the first race way, the material goes to the second and third turnplate. The blower inhales the external air into the mill and carries the powder after third turnplate into powder-separator. Turbine in the separator makes the coarse powder drop down and regrinded and the fine powder shall go into cyclone powder collector together with air current and go down through discharge valve as final product; At the same time, air current with a little dusts goes out through blower and muffler after purified by filter.

Capabilities and Characteristics:
Three-Ring & Medium-Speed MicroPowder Mill has high efficiency and low cost. Its capacity is raised by 40% compared with airflow mill and mix mill on the condition that the materials, the drive and the fineness of the final powder are the same. The life span of tear & wear parts is more than that of straight impact crusher and turbine mill under the circumstance of same materials and fineness of the final powder. Usually, its life span is more than one year. There is no rolling bearing and screw in the grinding cavity, so as to avoid the damage to the machine caused by tear & wear of bearing and seals and the looseness of screws. The fineness of powder can reachd 5¼m with d97 once.

Model HGM80
Diameter(mm) ¦800
Piece of roller: 21
Feed size(mm) d10
Fineness of powder (mm): 0.005-0.045
Capacity (kg/h)0.005-0.045
Total Power (Kw) 55
Weight of main frame (including motor) (t)7

Recommend to your friends