Products Catalog

Specification

MULTIPURPOSE HYDRAULIC OPERATING TABLEMODEL MT-505-l
( HEAD CONTROL)

FOR GENERAL, PROCTOLOGIC, CEREBRAL/ OPTHAL-MOLOGICAL & OTO-RHINO-LARYNGOLOGICAL, THORACIC, ARTHROSTEOPEDIC & STRUMA OPERASIONS.

Great Versatility In Positions:

General Surgery Position Maximum Trendelenburg Position
This is the most commonly used position. In this position, the patient is secured by
Height of the table top can be adjusted as required shoulder rest. It is suitable for gynecological surgery

Maximum Reversed Trendelenburg Position Kidney position
In this position, the foot rest is kept at a right With the kidney bridge elevated, the back and the
angle with the leg section to prevent the seat sections are in a “ break back� position for
patient from falling operations of kidney, lumbar region, abdomen, etc.

Lateral Tilt left / right Position
The table top can be tilted to the left or right side. Abdominal Reflex Position GGGGG
The body support are used to prevent the patient It is employed to relieve the muscular
from falling. This position is suitable for thoracic tension to facilitate suturing
and abdominal operations

Laminectomy/ Proctologic Position GGGGG Gynecological position
Suitable for anal operations, the patient lies on his Suitable for anal, urethral and perineal operations,
face with both legs separated and stretched such as haemorrhoidectomy uterine curettage,
downward or in a kneeling position cystoscopy, protoc – scopy, etc

Full Chair Position GGGGG
Suitable for oto-rhino-laryngological and cranial
Operations

Directions for use :

• Trendelenburg position, reversed trendelenburg position and lateral tilt in left or right direction are regulated by one single hand wheel. The movements of back section and the leg section are controlled by hand wheel. For directions for use please see the label attached to the crank sleeve.
• The kidney bridge is controlled by crank handle situated at the center.
• Both the ascending and descending movements of the table top are controlled by the oil pump. When the products leave the factory, the oil in the oil pump has been pumped into the pail, so the oil pump can not ascend. The consumers must loosen the cover of the filling aperture at the top of the oil pump and try to use the oil in the pail to refill the oil pump through the filling aperture slowly. By pressing down pedal repeatedly. The table top will elevate and stop automatically when the maximum height is reached. When the pedal is pressed down to its limit, the table top will begin to descend slowly and gently.
• The base of the table is mounted on ball castors and controlled by the floor brake, so that the table can be freely moved or stabilized at any desired position. When pedal is pressed down gently, the table can be pushed easily and when the same pedal is pressed down again, the base will be set stably on the floor.

Specifications:

Dimensions of table top
• Overall length : 20x20mm
• Width : 480mm
Dimensions of sections
• Head rest : 280 x 320mm
• Back section : 500 x 480mm
• Kidney bridge : 84 x 470mm
• Seat section : 370 x 480mm
• Leg section : 500 x 480mm
• Foot rest : 200 x 535mm
Table top from floor
• Max. height : 1040mm
• Min. height : 800mm
Range of movements
• Max. reversed trendelenburg : 55º
• Max. trendelenburg : 35º
• Max. lateral tilt : 20º
Adjustments of section
• Head rest – raised from the horizontal : 90º min.
• Lowered from the horizontal : 90º min.
• Back section – raised from the horizontal : 85º min.
• Lowered from the horizontal : 8º
• Kidney bridge elevation : 120mm
• Leg section – lowered from the horizontal : 90º min
Foot rest – can be kept horizontally or perpendicularly to the leg section