Specification :
PVC Gypsum Boards/PVC laminated gypsum ceiling board / Gypsum ceiling tiles
1) Specification:
Popular Size:
(1) Length and width
595x595mm,
600x600mm,
603x603mm,
600x1200mm,
603x1212mm, etc
(2)Thickness: 7.5mm, 8.0mm, 8.5mm, 9.0mm, 9.5mm, 12.0mm, etc
(3)Backing: aluminum foil backing or paper backing
(4) Surface: all kind of design and color PVC sheets
2) Pickings
Shrink foil carton, 6 or 8 or 10 or 12 pieces per carton
Loading: 20' containers FCL
3) Detailed Product Description
The PVC vinyl laminated plaster ceiling tiles are made of high quality paper-faced gypsum boards with laminated vinyl sheet of many patterns and aluminum foil on back. So it has good performances of fire-proof, moisture-proof, anti-sag and good appearance. It is a environmental friendly product. Fire-retardant
Waterproof and moisture
Free of odors and chemicals
Polymorphism (more than 30 model)
Easy to install
Stability and continuity.it is used as the ceiling of airport and subway building, hotel, office building, college, hospital, medicine workshop, residence house and other places under decoration etc.
Exterior Insulating Finishing System (insulation thermal mortar)
FEATURES AND BENEFITS
Water resistant
Excellent adhesion
Good flexural strength
Easy to use
Application:
1.Mortar Adhesive is used as an adhesive between substrates and expanded and extruded polystyrene boards (EPS & XPS boards).
Adhesive should be mixed on site with water in the ratio of approximately 4 parts Adhesive to 1 part water by weight, mixing with a high speed mixer for 3-5 minutes. Allow the material to stand for 10 minutes, remix and use. Mix only enough material for immediate use.
When used as an adhesive, apply to the EPS board and press into place using a level. Do not allow adhesive to skin before fixing in place. Clean tools and equipment with water after use.
2.EPS/XPS Board
3.Mechanical Fasteners
4.Mortar Base Coat is used as an adhesive between mineral substrates and expanded polystyrene boards (EPS boards).
Base Coat is used as an embedding mortar applied over the EPS boards to embed the glass fiber mesh prior to application of finish coats.
When used as an adhesive, apply to the EPS board and press into place using a level.
Do not allow adhesive to skin before fixing in place.
When used as an embedding mortar apply a coat of base Coat mix to the EPS board and embed the mesh using a trowel.
Apply another coat of mix to the surface to ensure full cover of the mesh and an overall thickness of approximately 3mm.
5.Decorative Finish Coating