Welcome to
ANYSCANCN COLTD

Free Member
ANYSCANCN COLTD
China
  • Products Catalog

    x-progm v5.0 full version

    Quantity Order:

    Specification :

    www.anyscancn.com

    email: andyjiaxu@ hotmail.com
    email: anysca ncn@ hotmail.com
    skype: anyscancn02
    msn: anyscancn@ hotmail.com
    yahoo: jiaxu_chen @ yahoo.com
    mobile: + 86-13417300945

    The XPROG-m programmer is designed to replace the earlier version of XPROG programmer.XPROG-m programmer is fully upward-compatible hardware with XPROG programmer and have many additional features.

    The XPROG-m supports in-circuit or on-board programming of Motorola 68HC05, 68HC08, 68HC11, 68HC( S) 12, HC912, MC9S12, MC9S12X, Texas Instruments TMS370, MPC5xx, ST10Fxx, ATmega family MCU' s and serial EEPROM' s.

    All supported devices are divided into " Software authorization" licenses. You can obtain authorization license only for these devices you are interested in.
    XPROG-m Rev. E functional features :
    - Fully compatible with all software versions of " Device Programmer Desktop" .
    - Software update ( ATMEGA) - directly from " Device Programmer Desktop" .
    - Software version control mechanism.
    - Self check for error handling.
    - Communication via USB 1.1 / 2.0 or high speed RS232 interface .
    - Fully upward-compatible XPROG connector.
    - Multi functional XPROG-m connector.
    - 8 pin DIP socket for on- board programming.
    - Supports many PLCC, QFP, LQFP adapters for on- board programming.
    - High speed hardware engine ( PLD) .
    - Two PWM regulated and ADC controlled voltage regulators.
    - K-Line interface pin.

    Hardware Specifications :
    Include high output current MPU.
    External output for on-board device programming.
    Serial port interface ( up to 115K baud) works on ( COM1, COM 2, COM3 or COM4) .
    USB 1.1 / 2.0

    Electrical Requirements :
    Power consumption : 300 mA.
    NOTE:
    If programmer connects to PC via RS-232 serial port, an external 12V DC power supply is needed.
    If programmer connects to PC via USB port , usually an external power supply is not needed, but be sure that USB can supply enough power.

    System Requirements for PC :
    - Processor: INTEL Pentium 60MHz or faster ( depends on operating system)
    - Memory ( RAM) : 32MB ( depends on operating system)
    - Hard drive: 5MB free space
    - Communication: One free physical COM-port or USB 1.1 / 2.0
    - Operating



You have [3] new inquiries.
Go to Member Menu

Home - Trade List - Product List - Inquiry List - Cooperation List - Company List
Copyright © 2024 Indomonster.com. All Rights Reserved.