Specification :

EQUOSTAT
The Equostat is a practical complement to Proceq’s portable rebound hardness testers as it resolves most limitations associated with the dynamic testing method.

While rebound hardness testers are not suitable to measure very light parts of certain geometries, the portable Equostat is well-suited for testing light, thin-walled or tubular parts.

The Equostat measures according to the Rockwell principle where the penetration depths under a defined preload are measured before and after application of a larger force.

These low-load penetration depth measurements are accurate, rapid and reproducible.

The difference between the before and after penetration depths reflects the plastic deformation and, therefore, the hardness.

Features
•Accurate, rapid and reproducible results from measurement of penetration depth
•Measurements are independent of the material and of the body dimensions
•Testing range from very soft (aluminum) up to very hard materials (case-hardened)
•Integrated conversions (HV, HB, HRC, HRB, HR15N, Rm)
•Transfer of up to 5’000 stored readings to a PC via RS232 using Equolink 2
•Excellent sensitivity down to small penetrations of only a few ¼m
•The probe can be used in either a clamp, bench press or freehand
•In addition to the R5 probe, all the impact devices of the Equotip 2 and Equotip 3 can be utilized to conduct rebound hardness testing with the same indicating deviceApplications
•Quality testing of very soft materials through to very hard materials
•Thin parts, profiles and pipes of a wall thickness d 2 mm, sheets, coiled metals, and pieces as thin as 0.2 mm (0.008�) depending on the hardness level
•Scratch-sensitive and polished surfaces
•Hardness of heat-affected zones near welding seams
Proceq offers accessories such as a hand activated clamp (incl. in the “clamp unit�), a free-hand flat foot (incl. in the “R-H unit�) for testing on large surfaces, support adapters for round parts, and a bench press to address individual testing requirements.

Warranties
•Standard 2-year limited warranty on electronic indicating units
•Optional extended warranty periods up to 3 years

Standardization
•DIN 50157
•DGZfP Guideline “Mobile Härteprüfung“
•VDI/VDE Guideline 2616 Paper 1
Technical Data
Equostat unit incl. R5 probe
Testing method static low-load Rockwell
Available probes R5 (also Leeb rebound probes can be used)
Test load preload 10N, total load 50N
Conical test tip diamond, point angle 80°
Min. radius of surface curvature 1.5 mm (0.06 in.)
Penetration depth soft materials approx. 80 ¼m (0.003 in.)

hard materials approx. 15 ¼m (0.0006 in.)
Resolution 0.1 HRZ; 1 HV; 1 HB; 0.1 HRB; 0.1 HRC; 0.1 HR15N; 1 MPa (1 N/mm2)
Accuracy ± 1.5 HRZ (± 2.0 HRC) throughout the entire measuring range
Equotip 2 indicating device
Dimensions 175 x 180 x 80 mm (6.9 x 7.1 x 3.15 in.)
Weight 750 g (incl. batteries)
Material shock resistant ABS plastic
Display large LCD
Internal data storage ~ 5’000 values
Communication RS232 C
PC application Equolink 2 software included
Battery type standard size "AA" cells (LR6) for about 65 h operation
Operating temperature 0 - 50 °C (32 - 122 °F)

http://www.proceq.com/products/metal-testing/portable-static-hardness-t esting/equostat.html?L=0