TP1650F-PL Automatic Wrapping machine( fssjn at hotmail dot com) Machine introduction This machine have powered outfeed conveyor and powered conveyorized turntable system and is able to transport an wrapped load from the turntable to the outfeed conveyor if there is no wrapped load on the outfeed conveyor. The operator can start wrap cycle by remote control allowing the operator to do other tasks. This arrangement eliminates the need for operators to place unwrapped loads on the floor, then pick them up again when the turntable is clear. During the machine auto wrap one palletized load, the operator can get one new unwrapped load, if there is no pallet on turntable, operator can put the new one, then take the wrapped load from the outfeed conveyor to the warehouse. Compared to a single turntable system. It increase fork lift efficiency and reduce handling time. Controls OMRON PLC control system Photo-eye pallet height sensor 0-9 separate top , bottom & up-down wrap count selectors Photoeye sensing delay Reinforce wrap allow more wrap on same location Film Tension Control adjustment on the panel 0— 15RPM variable turntable speed by frequency changer Separate variable carriage up/ down speed Cycle pause capability Separate start, reset and emergency stop buttons Manual carriage up/ down switch Turntable jog button Conveyor Jog ( for each conveyor) Dust-tight Precious Metal Slip-ring for long reliable service Remote Control Turntable 1800mm Diameter Structural steel plate 625mm high profile turntable Position turntable alignment Soft start/ Soft stop Heavy duty chain drive Table Fully Shrouded for Greater Personnel Safety Film Carriage Powered pre-stretch system up to 250% to min film consumption( Prestretch ratio can be specially made according your requirements.) Carriage door opens for effortless roll change and thread film Film delivery variable speed by separate DC Drive Motor Film dancer-bar with variable speed output Heavy duty double-chain carriage lift, calm and safety Conveyor Heavy Structural steel Frame construction All rollers driven Heavy Duty Conveyor Guards Adjustable Leg Height Different Roller Diameters and Roller Spacing Available Conveyor Speed: 12m per min( other speed available) Photo-eye Pallet Sensing and sequencing Technology Data Wrapping size L* W 500~ 1200 × 500~ 1200 mm Turntable diameter 1800mm Turntable Height 625mm Turntable weight capacity 2000kg Turntable speed 0-15rpm Machine weight 700kg Electrics 220V 50HZ 1Phase Power 2.3kw Air 0.4— 0.6 Mpa Packing efficiency 40-60 loads/ h base on load Option Packing height: 2800mm Turntable diameter: 2000mm Turntable capacity: 2500kg, 3000kg Addition conveyors & other type ( chain, belt ) available Other Hinged mast for easy handling Forklift transportable