Model : UNE 400

Standard delivery incubator:

The heating of this incubator is optimally tuned for both natural convection and forced air circulation; the fan can also be switched off completely, and valuable chamber loads for research, pharmaceutics, medicine and food chemistry are warmed up very carefully.

On this page, you can find all the essential technical data on our incubator. Our customer relations team will be pleased to help if you want further information. If you should require a customised special solution, please contact our technical specialists a

Ventilation and Control

natural convection
continuous adjustment of pre-heated fresh air admixture
vent connection with restrictor flap
fuzzy-supported PID microprocessor controller with integrated autodiagnostic system with fault indication
solid state switching unit
2 Pt100 sensors Class A in 4-wire-circuit, mutually monitoring and taking over the performance at the same temperature value
digital 7-day-programme-timer with real time clock, precise minute setting, for one set value or ramp operation in combination with:
integrated digital timer for tempering profile with max. 4 segments, each segment adjustable from 1 min to 999 hours:
DELAYED ON
HEATING UP
HOLD or HOLD set-temperature-dependent with guaranteed holding time
COOLING DOWN
" Loop" function to repeat profile 1-99 times or endless
digital display ( LED) of all set parameters, such as temperature, weekdays, time, programme status and set-up values
resolution of display for set value and actual value 0, 1 ° C
long-term logging ( ring store) of all relevant data, GLP-conforming as data logger - 1024 kB
serial interface RS 232 including MEMMERT Software " Celsius" for programming and documentation
incl. works calibration certificate for + 37 ° C

Triple Overtemperature Protection

in case of overtemperature due to failure, the heating is switched off at approx. 3 ° C above the set temperature ( fixed value)
independently working, digitally adjustable electronic overtemperature controller TWW protection class 3.1
resolution of display and setting accuracy: 0, 1 ° C
mechanical temperature limiter TB protection class 1 switching the heating off at approx. 10 ° C above max. oven temperature

Textured Stainless Steel Casing

w x h x d: 550 x 680 x 480 mm
fully insulated stainless steel door with double locking and 4-point adjustment
inner glass door
rear zinc-plated steel

Interior - Heating Concept

w x h x d: 400 x 400 x 330 mm, 53 l
easy-to-clean interior, made of stainless steel, reinforced by deep drawn ribbing with integrated and protected large-area heating on four sides
2 stainless steel grids

Temperature Range

from + 30 ° C ( however, at least 5 ° C above ambient) up to + 70 ° C

Voltage / Power Rating

230 V ( + / - 10% ) , 50/ 60 Hz
ca. 800 W ( during heating)
adaption of effective heating power depending on the set temperature

Packing Data

net weight approx. 38 kg
gross weight carton approx. 46 kg
dimensions approx.:
carton w x h x d: 67 x 78 x 63 cm
the appliances must be transported upright